HR205

This product range is now obsolete and no longer available from Vent-Axia. The information here is provided for reference only.

Controls condensation and odours
Up to 70% heat recovery
Balanced supply and extract air flows
Eliminates mould growth
Prevents noise ingress
Reduces maintenance costs
Cell bypassed when cooker hood is in boost mode
 

The HR205 unit is a residential mechanical ventilation designed solely to operate with the incorporated telescopic cooker hood. The unit transfers incoming fresh air, tempering it before it enters the habitable rooms. Its compact design allows installation within a standard kitchen cooker hob cupboard space.

Up to 185m³/h FID capacity (balanced airflow). Designed for use in apartments, flats and smaller dwellings. In particular those inner-city sites where noise ingress is a problem.

Installation
Designed for fitting above a residential cooker or residential hob. Units should be fitted a minimum of 700mm above the cooker/hob. Flat vertical area 1335mm high x 600mm wide is required for installation. The exhaust duct passes through an outside wall or roof and discharges to atmosphere in a suitable position. Clean air inlet duct passes through an outside wall or roof and should be suitably positioned to provide an adequate fresh air supply from atmosphere.

PERFORMANCE:

The MVHR unit has five normal fan speed settings and one boost setting. The performance curve chart gives the ventilation rates at each fan speed setting compared to the pressure drop of the system
When the telescopic hood is extended the MVHR unit switches automatically to boost. The hood passes the steam and fumes from cooking through the reticulated foam filters filters direct to the outside, bypassing the heat exchanger. The cooker hood must always be fully opened when the cooker/hob is in use.
HR205 to be used with an Integral Transformer for maximum controllabilty

Motor Speed 1 2 3 4 5 6
Volume m³/h (FID) 60 80 100 120 140 185

DIMENSIONS:

Weight: 20.60kg

Power Consumption  
 
Speed 1 80V 16W
Speed 2 100V 27W
Speed 3 120V 40W
Speed 4 140V 52W
Speed 5 160V 65W
Speed 6 240V 111W
Image of HR205
HR205
The HR205 unit is a residential mechanical ventilation designed solely to operate with the incorporated telescopic cooker hood. The unit transfers incoming fresh air, tempering it before it enters the habitable rooms. Its compact design allows installation within a standard kitchen cooker hob cupboard space. Up to 185m³/h FID capacity (balanced airflow). Designed for use in apartments, flats and smaller dwellings. In particular those inner-city sites where noise ingress is a problem.
Stock Ref. No: 372421
(Please call 0344 856 0590 0344 856 0590 for further availability information)

Find a Distributor

 

Raadpleeg de tab Downloads voor technische informatie

 

 

ESTIMATED RUNNING COSTS

Calculate estimated running costs for this product using the tool below.
For average costs*, leave the default values in place or enter your own figures in the boxes to recalculate.
Where a product has multi speeds, a typical installation has been used for the below calculations. *Running cost does not include the use of the heater on the heater model


pence
(Your current electricity cost in pence per hour. This will be listed on your electric bill)
hours
(The average number of hours per day fan to run in Trickle mode)
hours
(The average number of hours per day fan to run in Boost mode)

Based on the inputted figures, estimated running costs would be:

Overview

The HR205 unit is a residential mechanical ventilation designed solely to operate with the incorporated telescopic cooker hood. The unit transfers incoming fresh air, tempering it before it enters the habitable rooms. Its compact design allows installation within a standard kitchen cooker hob cupboard space.

Up to 185m³/h FID capacity (balanced airflow). Designed for use in apartments, flats and smaller dwellings. In particular those inner-city sites where noise ingress is a problem.

Installation
Designed for fitting above a residential cooker or residential hob. Units should be fitted a minimum of 700mm above the cooker/hob. Flat vertical area 1335mm high x 600mm wide is required for installation. The exhaust duct passes through an outside wall or roof and discharges to atmosphere in a suitable position. Clean air inlet duct passes through an outside wall or roof and should be suitably positioned to provide an adequate fresh air supply from atmosphere.

Technical

PERFORMANCE:

The MVHR unit has five normal fan speed settings and one boost setting. The performance curve chart gives the ventilation rates at each fan speed setting compared to the pressure drop of the system
When the telescopic hood is extended the MVHR unit switches automatically to boost. The hood passes the steam and fumes from cooking through the reticulated foam filters filters direct to the outside, bypassing the heat exchanger. The cooker hood must always be fully opened when the cooker/hob is in use.
HR205 to be used with an Integral Transformer for maximum controllabilty

Motor Speed 1 2 3 4 5 6
Volume m³/h (FID) 60 80 100 120 140 185

DIMENSIONS:

Weight: 20.60kg

Power Consumption  
 
Speed 1 80V 16W
Speed 2 100V 27W
Speed 3 120V 40W
Speed 4 140V 52W
Speed 5 160V 65W
Speed 6 240V 111W

Models

Image of HR205
HR205
The HR205 unit is a residential mechanical ventilation designed solely to operate with the incorporated telescopic cooker hood. The unit transfers incoming fresh air, tempering it before it enters the habitable rooms. Its compact design allows installation within a standard kitchen cooker hob cupboard space. Up to 185m³/h FID capacity (balanced airflow). Designed for use in apartments, flats and smaller dwellings. In particular those inner-city sites where noise ingress is a problem.
Stock Ref. No: 372421
(Please call 0344 856 0590 0344 856 0590 for further availability information)

Find a Distributor

Downloads

Related Products

Useful links