Lo-Carbon Kinetic Plus E

 

• Acoustic Enclosure option for reduced breakout noise
• Acoustic Top Box option for reduced in-duct noise
• Lightweight for easy installation
• Easy access filters
• External condensate connection
• Compatible with a range of controls: PIR, Humidistat
• Horizontal duct option for space-saving installations
• Up to 94% heat recovery
• Summer mode
• Manufactured in the UK
• Switched live inputs (Light switch control)

Select a product

A wholehouse heat recovery system with up to 94% energy efficiency. An easily accessible heat recovery cube protected by two removableISO 45% Coarse (G3) Filters. Two Lo-Carbon Energy Saving EC/DC fans ensure long life (typically over double the life of AC motors) and lowest possible energy use. Fully insulated construction with built-in condensation drain.

Lo-Carbon Kinetic Plus E meets the latest requirements of the Building Regulations Approved Document F for wholehouse system ventilation.

The Lo-Carbon Kinetic Plus E model has two adjustable speeds, normal and boost. On the front of the unit is the controller that can be used to preset the speeds to any required performance, up to 111l/s (400m3/hr) 150Pa. Offering ‘Close Control’ to prevent over ventilating.
Acoustically lined - low noise levels from only 20dB(A) @ 3m.

For scenarios where noise is a critical issue, an Acoustic Enclosure is available to reduce breakout noise and the Acoustic Top Box will reduce in-duct noise at key frequencies.

Left or Right Hand Installation
Units are supplied right handed with duct spigots to outside on the right hand side. These can be reversed onsite by simply removing the control panel, rotating the unit 180 degrees and reattaching the control panel.

Spigot Options
The combination of spigot options allows installation in confined locations. If vertical and horizontal connections are required on the same outlet/inlet, additional spigots can be supplied.

Filter Check
An LED on the control panel illuminates at 6 month intervals to remind
users to check and clean the filters.

Frost Protection
The Kinetic E range benefits from an automatic frost protection system to prevent the heat recovery cell freezing in very cold weather, while at the same time maintaining ventilation.

Control Options
There are two LS (Switched Live) inputs allowing the unit to be connected to a number of sensors and controllers such as Timespan, Ambient Response Humidistat. One of the LS connections also benefits from a ‘Delay-On’ feature which prevents the unit boosting unnecessarily.
Switching on the control panel allows activation of the Summer Mode.

Acoustic Solution
This product is available with acoustic enclosure. For more info please click here.

PERFORMANCE:

Click here for technical information, within our Online Product Selector. After, select your required fan model from the list to display Performance, Sound, Dimensions and Electrical Data

Image of Lo-Carbon Kinetic Plus E
Lo-Carbon Kinetic Plus E

High efficiency, SAP Appendix Q eligable, residential Mechanical Ventilation with Heat Recovery unit

Stock Ref. No: 449059
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Kinetic Plus E with Acoustic Enclosure & Top Box
Kinetic Plus E with Acoustic Enclosure & Top Box

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation.

Stock Ref. No: 479562
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Kinetic Plus E with Top Box
Kinetic Plus E with Top Box

The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation

Stock Ref. No: 479561
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Kinetic Plus E with Acoustic Enclosure
Kinetic Plus E with Acoustic Enclosure

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Stock Ref. No: 479560
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Isolator Relay Controller
Isolator Relay Controller
Allows fan unit to be isolated from other mains circuit when used with TIM2, Trickle/Boost switch or light switch control.
Stock Ref. No: 442030
Price £113.77 (excl VAT)
Image of Sentinel Kinetic Plus E/Plus/High Flow ISO ePM10 50% Pollen (M5) 1x Filter
Sentinel Kinetic Plus E/Plus/High Flow ISO ePM10 50% Pollen (M5) 1x Filter

ISO ePM10 50% (M5) Filter 1 Pack. Formally known as M5, this filter will remove smaller particles, including pollen.

Stock Ref. No: 444201
Price £62.35 (excl VAT)
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Spigot Pack 180/200mm Kinetic Plus
Single spigot pack increases the spigot diameter from 150mm to 180mm or 200mm. Compatible with the Sentinel Kinetic Plus.
Stock Ref. No: 446523
Price £18.13 (excl VAT)
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Sentinel Kinetic Plus E/Plus/High Flow ISO 45% Coarse (G3) 2x Filter
Sentinel Kinetic Plus E/Plus/High Flow ISO 45% Coarse (G3) 2x Filter

Sentinel Kinetic Advance Standard Filter -  ISO 45% Course  (G3) Filter 2 Pack. Formally known as G3, this filter will provide the minimum required filtration.

Stock Ref. No: 403702
Price £49.22 (excl VAT)

 

Raadpleeg de tab Downloads voor technische informatie

 

 

ESTIMATED RUNNING COSTS

Calculate estimated running costs for this product using the tool below.
For average costs*, leave the default values in place or enter your own figures in the boxes to recalculate.
Where a product has multi speeds, a typical installation has been used for the below calculations. *Running cost does not include the use of the heater on the heater model


pence
(Your current electricity cost in pence per hour. This will be listed on your electric bill)
hours
(The average number of hours per day fan to run in Trickle mode)
hours
(The average number of hours per day fan to run in Boost mode)

Based on the inputted figures, estimated running costs would be:

Overview

A wholehouse heat recovery system with up to 94% energy efficiency. An easily accessible heat recovery cube protected by two removableISO 45% Coarse (G3) Filters. Two Lo-Carbon Energy Saving EC/DC fans ensure long life (typically over double the life of AC motors) and lowest possible energy use. Fully insulated construction with built-in condensation drain.

Lo-Carbon Kinetic Plus E meets the latest requirements of the Building Regulations Approved Document F for wholehouse system ventilation.

The Lo-Carbon Kinetic Plus E model has two adjustable speeds, normal and boost. On the front of the unit is the controller that can be used to preset the speeds to any required performance, up to 111l/s (400m3/hr) 150Pa. Offering ‘Close Control’ to prevent over ventilating.
Acoustically lined - low noise levels from only 20dB(A) @ 3m.

For scenarios where noise is a critical issue, an Acoustic Enclosure is available to reduce breakout noise and the Acoustic Top Box will reduce in-duct noise at key frequencies.

Left or Right Hand Installation
Units are supplied right handed with duct spigots to outside on the right hand side. These can be reversed onsite by simply removing the control panel, rotating the unit 180 degrees and reattaching the control panel.

Spigot Options
The combination of spigot options allows installation in confined locations. If vertical and horizontal connections are required on the same outlet/inlet, additional spigots can be supplied.

Filter Check
An LED on the control panel illuminates at 6 month intervals to remind
users to check and clean the filters.

Frost Protection
The Kinetic E range benefits from an automatic frost protection system to prevent the heat recovery cell freezing in very cold weather, while at the same time maintaining ventilation.

Control Options
There are two LS (Switched Live) inputs allowing the unit to be connected to a number of sensors and controllers such as Timespan, Ambient Response Humidistat. One of the LS connections also benefits from a ‘Delay-On’ feature which prevents the unit boosting unnecessarily.
Switching on the control panel allows activation of the Summer Mode.

Acoustic Solution
This product is available with acoustic enclosure. For more info please click here.

Technical

PERFORMANCE:

Click here for technical information, within our Online Product Selector. After, select your required fan model from the list to display Performance, Sound, Dimensions and Electrical Data

Models

Image of Lo-Carbon Kinetic Plus E
Lo-Carbon Kinetic Plus E

High efficiency, SAP Appendix Q eligable, residential Mechanical Ventilation with Heat Recovery unit

Stock Ref. No: 449059
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Kinetic Plus E with Acoustic Enclosure & Top Box
Kinetic Plus E with Acoustic Enclosure & Top Box

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation.

Stock Ref. No: 479562
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Kinetic Plus E with Top Box
Kinetic Plus E with Top Box

The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation

Stock Ref. No: 479561
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Kinetic Plus E with Acoustic Enclosure
Kinetic Plus E with Acoustic Enclosure

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Stock Ref. No: 479560
(Please call 0344 856 0590 0344 856 0590 for further availability information)

Accessories

Image of Isolator Relay Controller
Isolator Relay Controller
Allows fan unit to be isolated from other mains circuit when used with TIM2, Trickle/Boost switch or light switch control.
Stock Ref. No: 442030
Price £113.77 (excl VAT)
Image of Sentinel Kinetic Plus E/Plus/High Flow ISO ePM10 50% Pollen (M5) 1x Filter
Sentinel Kinetic Plus E/Plus/High Flow ISO ePM10 50% Pollen (M5) 1x Filter

ISO ePM10 50% (M5) Filter 1 Pack. Formally known as M5, this filter will remove smaller particles, including pollen.

Stock Ref. No: 444201
Price £62.35 (excl VAT)
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Spigot Pack 180/200mm Kinetic Plus
Single spigot pack increases the spigot diameter from 150mm to 180mm or 200mm. Compatible with the Sentinel Kinetic Plus.
Stock Ref. No: 446523
Price £18.13 (excl VAT)
(Please call 0344 856 0590 0344 856 0590 for further availability information)
Image of Sentinel Kinetic Plus E/Plus/High Flow ISO 45% Coarse (G3) 2x Filter
Sentinel Kinetic Plus E/Plus/High Flow ISO 45% Coarse (G3) 2x Filter

Sentinel Kinetic Advance Standard Filter -  ISO 45% Course  (G3) Filter 2 Pack. Formally known as G3, this filter will provide the minimum required filtration.

Stock Ref. No: 403702
Price £49.22 (excl VAT)

Downloads